Skip to content
Reroot Bio

E-Commerce & Shipping Packaging

Shipping Mailers for Your Parcels

Measure the parcel after folding, wrapping or boxing it. A flat product measurement misses the thickness that the mailing bag must accommodate. Record the packed width, length and thickness before choosing a bag.

Thickness
60 μm
Bags / carton
1000
Catalogue MOQ reference (bags)
50,000

Will the parcel fit below the sealing flap?

Keep the body and flap separate

Draw the opening, usable body and flap as separate parts. The existing mailer catalogue reference lists thickness and packing, but its original size notation has no confirmed unit. A photograph or familiar-looking size is not enough to assign millimetres or centimetres. Send a measured bag or drawing with the unit marked.

A return strip is a requirement, not an assumption

If the buyer needs a return journey, show where a second seal would be used and how the first closure would be opened. Ask to review the actual closure sample and sealing sequence. The supplied detail illustrations do not establish that every configuration has two strips, or prove waterproofing or tamper resistance.

Can I order by the size shown in the image?

Use the image to identify the format, then provide a dimension drawing with units and a packed-item reference. The current catalogue does not establish the mailer's size unit.

What should I send for a branded mailer quote?

Include the parcel measurements, closure or return-seal requirement, quantity unit, artwork and destination. Keep courier-label space clear on the proposed drawing.

Catalogue configurations

These are catalogue reference configurations. Final dimensions, material formulation, tolerances, packing and order quantities are confirmed in the quotation and approved specification.

Catalogue material description · PBAT + PLA + corn starch

Catalogue colours · Black / Green

Scroll the table to see all columns.

Catalogue size and packing references
Reference / FormatDimensionsThicknessPackingMOQ reference / bagsEnquire
Catalogue reference 09-01 · Shipping Mailers Confirm for project 60 μm Bags / carton 1000 50,000 Request a Quote

Can the same shipping mailer be used for a customer return?

Put one complete order through a trial at the packing bench before specifying a return mailer. The question is whether someone can open the outbound parcel, put the item back and make a clearly addressed return using the material that remains.

Pack a representative order and mark the opening

Use the actual garment bundle or box, including any insert that will travel back. Seal it as for dispatch and attach a void sample shipping label where your fulfilment team normally puts it. Check whether that label covers the opening instructions, perforation or any strip reserved for a second closure.

Hand the parcel to someone who has not packed it

Give the tester the same instructions a customer would receive. After opening, lay the flap flat and look for torn film, a shortened flap or adhesive used up on the outbound trip. Repack the contents. If a second strip is specified, check that its liner is still intact and the strip meets clean film across the opening without stretching.

Check which shipping label the carrier will see

Follow the chosen carrier’s procedure for removing or covering the outbound shipping label. Apply a void return label and check that its full routing barcode is readable on the repacked parcel. A label that lies flat on an empty bag may wrap around a corner once the box goes back in.

Keep photos of the first closure, the opened flap and the return-ready parcel with the sample reference. Record whether the return worked unaided, needed extra tape or needed a new bag. Use that result when comparing quotations.

Request Samples